Integra DRX-8.4 User Manual

151
SetupSetup
6. Hardware
 2. Network
Change the settings of the Network function.
• When LAN is congured with a DHCP, set "DHCP" to "Enable" to congure
the setting automatically. ("Enable" is set by default) To assign xed IP
addresses to each components, you must set "DHCP" to "Disable", assign an
address to this unit in the "IP Address" setting, and set information related to
your LAN, such as Subnet Mask and Gateway.
 Wi-Fi (Default Value: O󰀨(Wired))
Connect the unit to the network via a wireless LAN router.
• When switching between "On" and "O󰀨(Wired)", stop the Network service.
Also, when group playback is in process, cancel the group playback once, and
then switch the setting.
On Wireless LAN connection
O󰀨(Wired) Wired LAN connection
 Wi-Fi Setup (Default Value: -)
Congure wireless LAN settings by pressing Enter with "Start" displayed.
 Wi-Fi Status (Default Value: -)
The information of the connected access point is displayed.
SSID SSID of the connected access point.
Signal Signal strength of the connected access point.
Status Status of the connected access point.
 MAC Address (Default Value: -)
Check the MAC address of this unit.
This value is specic to the component and cannot be changed.
 DHCP (Default Value: Enable)
Enable Auto conguration by DHCP
Disable Manual conguration without DHCP
• If you select "Disable", set "IP Address", "Subnet Mask",
"Gateway", and "DNS Server" manually.
 IP Address (Default Value: 0.0.0.0)
Displays/Sets the IP address.
 Subnet Mask (Default Value: 0.0.0.0)
Displays/Sets the subnet mask.
 Gateway (Default Value: 0.0.0.0)
Displays/Sets the gateway.
 DNS Server (Default Value: 0.0.0.0)
Displays/Sets the primary DNS server.
 Proxy URL (Default Value: -)
Displays/Sets the proxy server URL.
 Proxy Port (Default Value: 8080)
Displays/Sets the proxy server port number when you input "Proxy URL".

Integra DRX-8.4 Specifications

General

Channels	11.2
Amplification Type	Class AB
THD+N	0.08%
HDMI Inputs	7
HDMI 2.1	Yes
HDR Support	HDR10, Dolby Vision, HLG
eARC	Yes
Phono Input	Yes
Zone 2/3 Powered Outputs	Yes
USB Input	1 (Front)
Ethernet	Yes
Wi-Fi	Yes
Bluetooth	Yes
Standby Power Consumption	0.15 W
Power Output (8 Ohms, 20 Hz-20 kHz, 0.08% THD, 2 Channels Driven, FTC)	140W
Power Output (6 Ohms, 1 kHz, 10% THD, 1 Channel Driven)	250 W/Ch
Input Sensitivity and Impedance	200 mV/47 kOhms (Line)
Signal-to-Noise Ratio	106dB
Speaker Impedance	4 Ohms – 16 Ohms
HDMI Outputs	3
Digital Audio Inputs	Optical: 2, Coaxial: 1
Pre-Outs	11.2 Ch
Speaker Terminals	11
Streaming Services	AirPlay 2, Spotify, Tidal, Deezer
Voice Control	Amazon Alexa, Google Assistant
Room Correction	AccuEQ
Supported Audio Formats	Dolby Atmos, DTS:X
Weight	14.5 kg (32 lbs.)