Design and Environmental SpecificationsIntel® Server Board S2600IP and Intel® Workstation Board W2600CR TPS
Revision 1.1
Intel order number G34153-003
Table 64. Loading Conditions
9.4.3 Standby Output
The 5VSB output shall be present when an AC input greater than the power supply turn on
voltage is applied.
9.4.4 Voltage Regulation
The power supply output voltages must stay within the following voltage limits when operating at
steady state and dynamic loading conditions. These limits include the peak-peak ripple/noise.
These shall be measured at the output connectors.
Table 65.Voltage Regulation Limits
9.4.5 Dynamic Loading
The output voltages shall remain within limits specified for the step loading and capacitive
loading specified in the table below. The load transient repetition rate shall be tested between
50Hz and 5kHz at duty cycles ranging from 10%-90%. The load transient repetition rate is only
a test specification. The step load may occur anywhere within the MIN load to the MAX load
conditions.
Table 66. Transient Load Requirements
Step Load Size
(See note 2)
Notes: