Intel SCB2 - Server Board Motherboard User Manual

44 Intel Server Board SCB2 Product Guide
Run the System Setup Utility (SSU) to setup the following:
• Enable Server Management Features
• Read System Event Log (SEL)
• Read Sensor Data Records
• Read System FRU Information
• Specify boot device sequence
• Setup system passwords
Record BIOS Setup Settings
Record your BIOS Setup settings. If default values ever need restoring (after a CMOS clear, for
example), you must run BIOS Setup again. Your record will make this much easier.
If BIOS Setup Is Inaccessible
If you have a misconfigured diskette drive, and you cannot use BIOS Setup to correct the problem,
you might need to clear CMOS memory. To clear CMOS, either of two methods can be used.
1. Press the reset button and hold it down for four seconds or more, and then, while holding the
reset button down, press the power button. Release both buttons at the same time.
2. Move the “Clear CMOS” jumper found on the configuration jumper block on the baseboard.
BIOS Setup Menus
Table 7. BIOS Setup Menu Navigation
To: Press:
Get general help <F1> or <Alt+H>
Move between menus
← →
Go to the previous item
↑
Go to the next Item
↓
Change the value of an item + or -
Select an item or display a submenu <Enter>
Leave a submenu or exit BIOS Setup <Esc>
Reset to BIOS Setup defaults <F9>
Save and exit BIOS Setup <F10>

Intel SCB2 - Server Board Motherboard Specifications

General

Brand	Intel
Model	SCB2 - Server Board Motherboard
Category	Server Board
Language	English