Advisor Advanced ATSx000A(-IP) Installation and Programming Manual 85
A PIN is generated by selecting Yes and pressing Enter in this menu. The
generated PIN is shown until Enter is pressed again.
PINs are entered manually.
Pressing Enter lets you enter or edit the PIN of the selected user.
The PIN change mode can be set in menu “8.7.6 PIN chg mode” (see page 155).
PIN length is programmed using “8.7.5 PIN length” on page 155. The number of
available PINs varies from 10000 (for 4-digit PINs) to 10000000000 (for 10-digit
PINs).
No PINs are reserved for system use. Any PIN can be generated or entered for
use. PINs must be unique. A PIN cannot be assigned to more than one user. The
system will not generate or accept entry of PINs already in use.
3.1.n.2.2 Remote PIN
Remote PIN is a PIN for programming the panel via remote connection. If remote
PIN is not set, the installer uses local PIN to log in remotely.
Note: This submenu is available for installer only.
See “Remote access” on page 42 for more details.
3.1.n.2.2.1 Set PIN
Set remote PIN.
To enable remote PIN, use “3.1.n.2.2.2 Enable login” below.
3.1.n.2.2.2 Enable login
Use the command to enable remote PIN.
See “3.1.n.2.2 Remote PIN” above for more details.
3.1.n.3 User card
1>Assign card
Card not set
The User card menu lets you assign or delete a user card.
The content of the menu depends whether a card has been already assigned or
not.
To Next Page
Loading...
Need help?
General
