Interlogix NXG-4-RF-BO User Manual

94 xGen Lite Installation and Programming Guide
Programming with DLX900
This section of the manual will describe the steps needed to program each
feature using the DLX900 software.
Selected screen shots of the xGenLite Web Server are also included for your
reference. Similar screens appear on the UltraSync+ app.
Programming Instructions for System Options
Goal
Program System Options including time and date, tamper, siren, timers, and
service settings.
Pre-conditions
Time and date are automatically updated using an Internet time server by default,
this setting is enabled under Communicator > IP Config.
If you want to allow xGenLite to send diagnostic emails then check email is set
up correctly under Communicator > Email and xGenLite is connected to
a network.
Note: Ensure you set the correct time zone here.
Programming Sequence
2. System
a) System Clock
b) System and Siren
c) Timers
d) Maintenance and Test

Interlogix NXG-4-RF-BO Specifications

General

Brand	Interlogix
Model	NXG-4-RF-BO
Category	Security Sensors
Language	English