Interlogix NXG-4-RF-BO - Programming Instructions for Communicator

126 xGen Lite Installation and Programming Guide
At 5pm each weekday the system would arm Areas 1, 2, and 3 as if it were user
55 and report those arm events (closings) to the communication channels
specified.
Arm-Disarm Number 1 – Arm-Disarm Example
Schedule 4 – Office Hours
Mon – Fri
9 AM – 5 PM

See “Programming
Instructions for Schedules”
on page 117 to program
User 55 – Arm-Disarm User

See “Programming
Instructions for Users” on
page 105 to program
Permission 99 – Full Access

See “Programming
Instructions for Permissions”
on page 98 to program
Arm Area Group 1
1, 2, 3
Arm Area Group 1
1, 2, 3
Schedule 1 – Full Access
7 days, 24 hours

See “Programming
Instructions for Schedules”
on page 117 to program
Programming Instructions for Communicator
Goal
Configure each communication path for delivering event messages.
Pre-conditions
None.
Programming Sequence
6. Communicator
a) Options
b) IP Config
c) Ethernet
d) Radio
e) Dial IP
f) Email
g) Remote Access
h) System Event Reporting
18. Channel Groups