xGen Lite Installation and Programming Guide 131
5. Enter the required details into your device/software. This will usual be your
xGenLite serial number, Web Access Passcode, and a valid Username and
PIN code. The xGenLite serial number can be found in the Device Info menu.
6. Verify the UltraSync service is working by using your device/software to
connect your xGenLite system.
Troubleshooting
• Check the Web Access Passcode is correct. It cannot be 00000000.
• Check there is a valid user and they have a First name, this will be the login
name.
• Check the serial number is correct. It is printed on the xGenLite module.
• Check that the user permissions are currently valid.
See also “Appendix 2: App and Web Error Messages” on page 154.
Programming Instructions for Event Lists
Goal
Create segmented lists of events so Channels can selectively deliver event
messages.
Pre-conditions
None.
Notes
If an event message is enabled in an Event List, then the Channel will attempt to
deliver it. If an event message is not enabled on the Event List, the Channel will
not attempt delivery even if the message has been sent to it.
Event List set up for push notifications is automatically performed by the
UltraSync+ app when required. The panel will assign the next available channel
and matching event list number. No configuration via the web pages or DLX900
is required.
Programming Sequence
To Next Page
Loading...
Need help?
General
