EasyManuals Logo

Interlogix NXG-4-RF-BO User Manual

Interlogix NXG-4-RF-BO
170 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #152 background imageLoading...
Page #152 background image
140 xGen Lite Installation and Programming Guide
Take note of the Sequence Attempts under Communicator > System Event
Reporting (6.11.2). This is the number of times xGenLite will attempt the
sequence of Channels you set up in this section.
Programming Sequence
17. Event Lists
5. Channels
18. Channel Groups
6. Communicator
17. Event Lists
6. Communicator
a) Options
b) IP Config
c) Ethernet
d) Radio
e) Dial IP
f) Email
g) Remote Access
h) System Event
Reporting
18. Channel Groups
Instructions
1. Go to Communicator, System Event Reporting.
2. Select a Channel Group.
Done. The xGenLite will now report system events to the Channels selected in
the Channel Group you just selected.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Interlogix NXG-4-RF-BO and is the answer not in the manual?

Interlogix NXG-4-RF-BO Specifications

General IconGeneral
BrandInterlogix
ModelNXG-4-RF-BO
CategorySecurity Sensors
LanguageEnglish

Related product manuals