150 xGen Lite Installation and Programming Guide
Activate SOS Feature
Touch the SOS button to display the SOS feature:
On this screen touch and hold the appropriate button for 2 seconds to activate
Manual Fire Alarm, Manual Auxiliary Alarm, or Manual Panic Alarm. These
buttons can be enabled and disabled in the Area Options menu.
Depending on how your system is programmed, the control room may receive
the corresponding event. Check with your control room to determine what action
will be taken.
If silent alarm is enabled, then the keypad will not display any signs that the panic
button was pressed.
To cancel a SOS alarm – return to the home screen, touch the Status button and
turn the Area off.
Walk Test
1. Log in to panel web page.
2. Click Settings.
3. Click Walk Test.
4. Click Start.
5. Trigger each sensor by walking past PIRs, opening and closing reed
switches, pressing tamper buttons, etc. Siren will chirp multiple times for each
zone triggered.
6. Click Stop.
7. Click History.
To Next Page
Loading...
Need help?
General
