32 xGen Lite Installation and Programming Guide
You should now see a screen similar to:
Troubleshooting
If you are unable to get an IP address in step 3, then your (wireless) router may
not be configured for automatic DHCP or certain security settings may be
enabled.
• Check your router settings and try again.
• On a NXG-820 touchscreen keypad press Menu, PIN, ENTER, go to Installer
> Communicator > IP Configuration > IP Options. “Enable DHCP” should be
ticked, “Disable Web Pages on LAN” should be unticked.
Check LAN Connection to UltraSync
UltraSync is a cloud-based service that allows remote management and remote
access to a xGenLite system if enabled. This includes secure connections
between the UltraSync+ app, xGenLite, and cameras. No programming, email
addresses, user names, or PIN codes are stored on these servers for greater
security.
It features full redundancy to route encrypted alarm messages from your panel to
a Central Monitoring Station.
1. Log in to the Web Server as shown above
2. Click Settings
3. Select Connection Status in the drop-down menu
4. Check:
- LAN Status should display “Connected”
- UltraSync Status should display “Connected”
- UltraSync Media should display “LAN” for Ethernet and “dual-path” for dual
path
- UltraSync Media should display “Cellular” for single-path cellular
To Next Page
Loading...
