36 xGen Lite Installation and Programming Guide
2. Enter a new PIN code.
Connect to xGenLite via UltraSync+ app
UltraSync+ is an app that allows you to control your xGenLite system from an
Apple® iPhone/iPad, or Google Android device. First set up the xGenLite Web
Server then download this app. Carrier charges may apply and an Apple iTunes
or Google account is required.
1. On your smartphone go to the Apple® App Store
TM
or Google Play
TM
store.
2. Search for UltraSync.
3. Install the app.
4. Click the icon on your device to launch it.
5. Click + on the top right to add a new site, or the (i) icon to edit an existing site.
6. Enter the details of your security system.
Locate the 12-digit serial number barcode on the xGenLite circuit board.
Alternatively log in to xGenLite Web Server and go to Settings > Details to
view it.
The default Web Access Passcode of 00000000 disables remote access. To
change it, log in to xGenLite Web Server and go to Settings > Network.
The default username and PIN code is “installer” 9713 (for an installer) and
“User 1” 1234 (for a user). Please note that there is a space between “User”
and “1”. You may also use any other valid user account. Only menus a user
has access to will be displayed.
Note: EN 50131 Grade 2 default codes are 971300, 123400.
7. Click the Done button to save the details, then Sites to go back.
8. Click the name of the Site, the app will now connect you to xGenLite.
Using the App
The first screen that will appear once you connect is the Overview screen. This
will display the status of your system and allows you to arm or disarm partitions
by touching Arm Away, Arm Stay, or Disarm. It also allows you to activate
programmed automation scenes.
To Next Page
Loading...
Need help?
General
