Chapter 3 — Developing and Using RFID Applications
IF61 Fixed Reader User’s Manual 69
Use this setting to attenuate the antenna field strength. In some
situations, full output power can cause unnecessary interference.
For example, if the tag is close to the antenna, full output power
might overload the tag and cause unreliable behavior.
This setting is equivalent to the FIELDSTRENGTH BRI
attribute.
Antenna Sequence: First through Eighth
Sets the RFID antenna to be used for each of up to eight tag
inventory operations. Choose any one of the four available
antennas from the drop-down list. If more than one antenna is
enabled, the antennas fire in this sequence.
This setting is equivalent to the ANTS BRI attribute.
Configuring the BRI Server
The IF61 BRI server handles communication between your
application and the RFID module. When your application is
communicating with the BRI server, the blue Intermec Ready-
To-Work Indicator on the IF61 front panel turns on and stays on.
For more information, see “About the Intermec Ready-To-Work
Indicator” on page 7.
To configure BRI server settings
1 From the menu, click RFID Services > BRI > BRI Server.
The BRI Server screen appears.
2 Change BRI server settings as needed. For help, see the next
table.
To Next Page
Loading...
