Intermec IF61

Chapter 1 — Getting Started
8 IF61 Fixed Reader User’s Manual
Understanding the Top Panel Ports
Connect RFID and 802.11 radio antennas to the ports on the
IF61 top panel.
IF61 Top Panel Ports: This illustration shows the ports on the top panel. The
IF61 ships with antenna terminators mounted on RFID antenna ports 2, 3, and
4.
The IF61 RFID antenna ports use these connectors:
• 865-869 MHz: SMA
• 915 MHz: Reverse SMA
Make sure you have appropriate antennas and cables for your
IF61. For help, contact your Intermec sales representative.
RFID antenna ports
(4 places)
802.11
antenna ports
(2 places)
Government regulatory agencies require that this RFID reader
uses only approved antennas. Therefore, this reader uses a
custom antenna connector. Do not use antennas not approved
for use with this reader.
Note: The IF61 ships with antenna terminators installed on
RFID antenna ports 2, 3, and 4. Do not remove the terminator
from any port unless you are installing an antenna or antenna
cable on that port.