Intermec IF61

Chapter 3 — Developing and Using RFID Applications
66 IF61 Fixed Reader User’s Manual
No Tag Report
Enables or disables a NOTAG message, which is sent when no
tags are found during execution of a Read, Write, or Lock
command. Check the check box to enable the message. This
setting is equivalent to the NOTAGRPT BRI attribute, and is
enabled by default.
Report Timeout
Sets the timeout (in ms) for delays in tag reporting when the
IF61 is in continuous read mode. Range is 0 (default) to 65534.
Timeout Configuration Mode
Enables a timeout mode. Instead of specifying the number of
antenna or ID tries, you specify an antenna or ID timeout value.
If the IF61 does not find any tags after an antenna or ID try, the
reader waits this long before starting the next antenna or ID try.
If you enable timeout mode, you need to set the ID Timeout and
Antenna Timeout values.
This setting is equivalent to the TIMEOUTMODE BRI
attribute, and is disabled by default.
To enable Timeout Configuration mode
1 Check the check box and then click Activate Changes. The
screen refreshes. The Antenna Tries setting is replaced by
Antenna Timeout, and the ID Tries setting is replaced by ID
Timeout.
2 Specify the value (in ms) for the antenna or ID timeout in the
entry fields and then click Activate Changes.
For more information on ID Timeout and Antenna Timeout,
see those topics later in this section.
Select Tries
(Not supported by EPCglobal Class 1 Gen 2 tags) Sets the
number of times a group select is attempted. A group select is the
command that starts the identity process. Valid range is 1
(default) to 254.
This setting is equivalent to the SELTRIES BRI attribute.
Unselect Tries
(Not supported by EPCglobal Class 1 Gen 2 tags) Sets the
number of times a group unselect is attempted. Valid range is 1
(default) to 254.