Chapter 1 — Getting Started
IF61 Fixed Reader User’s Manual 17
8 Install the top half of the cable cover. Make sure the cables are
not caught in the seam.
9 Place the IF61 in its mounting location. For help, see
“Choosing a Mounting Location” on page 15.
10 Connect the Ethernet cable to your network.
11 Connect the AC power cord to an AC outlet. When you
apply power, the IF61 boots and the green Power LED turns
on.
The IF61 is now ready to communicate with your network. Once
the IF61 has been assigned an IP address (either manually or
from your DHCP server), you can use the web browser interface
to complete configuration. For help, see “Using the Web
Browser Interface” on page 11.
Setting the Date and Time
After you have installed the IF61, you can set the date and time
via the web browser interface.
To set the date and time
1 Connect to the IF61 via the web browser interface. For help,
see “Using the Web Browser Interface” on page 11.
2 In the web browser screen, click the date and time in the
upper right-hand corner. The Time screen appears.
Note: If you are using a DHCP server, make sure the server is
running before you connect power to the IF61.
To Next Page
Loading...
