Chapter 2 — Configuring Network Settings
IF61 Fixed Reader User’s Manual 41
4 Click Activate Changes to save your settings and
immediately make them active.
Configuring WPA Personal (PSK) Security
1 From the menu, click Network Configuration > 802.11 or
802.11 Configuration. The 802.11 Configuration screen
appears.
Parameters for Dynamic WEP/802.1x Security
Parameter Description
Allowed EAP
Authentication
Method
Specifies which 802.1x authentication protocol (TLS,
TTLS, PEAP, or LEAP) the IF61 sends to the
authentication server.
Username User name for the selected protocol.
Password Password for the selected protocol.
Validate CA
Certificate
Enables or disables verification of the server
certificate signature against the certificate installed on
the IF61. If you enable verification, you need to
specify the CA certificate common name.
CA Certificate
Common
Name
Common name for the server certificate.
Reject Expired
Certificates
Check this check box to reject expired certificates.
Enable mixed
cell
Enable this mode to allow the IF61 to communicate
with CCX mixed-cell access points. Mixed-cell use
allows both WEP and non-WEP clients to
communicate with the same access point.
To Next Page
Loading...
