Chapter 2 — Configuring Network Settings
IF61 Fixed Reader User’s Manual 39
3 Configure the parameters for WEP security. To ensure
maximum security, configure each WEP key with a different
WEP code. For help, see the next table.
4 Click Activate Changes to save your changes and
immediately make them active.
.
Configuring Dynamic WEP/802.1x Security
1 From the menu, click Network Configuration > 802.11 or
802.11 Configuration. The 802.11 Configuration screen
appears.
Parameters for Static WEP Security
Parameter Description
WEP Key 1 through
WEP Key 4
For WEP 64, enter five ASCII characters or hex
pairs. For WEP 128, enter 13 ASCII characters
or hex pairs.
For example, an ASCII WEP key of ABCDE
would be entered in hex format as
4142434445.
WEP Transmit Key Chooses the WEP key this IF61 uses to encrypt
transmitted data. Default is 1.
Authentication
Method
Specifies whether encryption will be used as
part of the authentication algorithm to
authenticate the IF61. Choose Shared Key to
require encryption or Open System to require
no encryption.
Enable mixed cell Enable this mode to allow the IF61 to
communicate with CCX mixed-cell access
points.
To Next Page
Loading...
