Chapter 2 — Configuring Network Settings
36 IF61 Fixed Reader User’s Manual
2 Make sure the Enable RADIUS check box is not checked.
Uncheck this check box if necessary and then click Activate
Changes.
3 Configure the parameters. For help, see the next table.
4 Click Activate Changes to save your changes and
immediately make them active.
Disabling Access Via the Serial Port
When serial port access is disabled, you will not be able to
configure the IF61 as described in “Assigning an Initial IP
Address” on page 9. You must use the web browser interface for
all configuration.
To disable serial port access
1 From the menu, click Security > Passwords. The Passwords
screen appears.
Password Parameter Descriptions
Parameter Description
Username Enter the user name you need to use to log in
to this IF61. The user name can be from 1 to
32 characters long. You must always specify a
user name. Default is
intermec.
Password Enter the password you need to use to log in to
this IF61. This password gives you read and
write access to the IF61 configuration. The
password can be from 8 to 32 characters long.
You must always specify a password. Default is
intermec.
Read-only Password Enter the password you need to use to log in to
this IF61. This password gives the user read-
only access to the IF61. This user can view the
configuration and execute diagnostics but
cannot perform any tasks that affect IF61
operation, such as changing configuration
options or downloading software. Default is
readonly.
The read-only password cannot be deleted. To
disallow read-only access, you need to enable
RADIUS authentication. For help, see
“Configuring Security” on page 30.
To Next Page
Loading...
