Chapter 1 — Getting Started
IF61 Fixed Reader User’s Manual 11
If you need to change the values for subnet mask or the IP
router, continue with the next step.
6 To set the subnet mask, press 2 and enter the subnet mask
value in the entry field. Press Enter to save the changes.
To set the IP router address, press 3 and enter the IP router
address in the entry field. Press Enter to save the changes.
7 (Optional) To change the Ethernet link speed, press L and
choose a link speed from the list of options:
8 Press Q to close the Initial Configuration screen.
9 Disconnect the null-modem cable from the IF61.
The IF61 is now ready to be connected to your network. See
“Connecting the IF61 to Your Network” on page 16.
Using the Web Browser Interface
After the IF61 is assigned an IP address, configure the IF61 using
the web browser interface.
To use the web browser interface, the IF61 must be connected to
your wired network. For help, see “Connecting the IF61 to Your
Network” on page 16.
When using the web browser interface, remember that your
session terminates if you do not use it for 15 minutes.
Ethernet Link Speed Options
To choose this speed: Press:
Auto detect (default) A
100 Mbps - full duplex 1
100 Mbps - half-duplex 2
10 Mbps - full duplex 3
10 Mbps - half duplex 4
Keep the current selection and
close this dialog box
Q
Note: If you access the Internet using a proxy server, add the IF61
IP address to your Exceptions list. The Exceptions list contains
the addresses that you do not want to use with a proxy server.
To Next Page
Loading...
