Chapter 1 — Getting Started
10 IF61 Fixed Reader User’s Manual
2 Typ e config and press Enter, and then type config again in
the Password field and press Enter. The IF61 Initial
Configuration screen appears.
By default, DHCP is enabled. Because the IF61 is not yet
connected to your network, it has not been assigned an IP
address and “No Address Established” appears in the window.
3 Press D. DHCP is disabled and the Ethernet Configuration
Options screen appears.
4 To set the IP address, press 1 and enter the static IP address in
the entry field.
5 Press Enter. The static IP address is set. If you do not need to
set the subnet mask or IP router values, you can now continue
to configure the IF61 through the web browser interface. For
help, see “Using the Web Browser Interface” on page 11.
To Next Page
Loading...
