INVT IPE300 Series - Page 175

IPE300 series engineering VFD Function parameter list
-164-
Function
code
Name
Description
Default
Modify
1: Valid during running, cleared after stop
2: Valid during running, cleared after a stop
command is received
P08.45
Frequency
increment
integral rate of
the UP terminal
0.01–50.00Hz/s
0.50Hz/s
○
P08.46
Frequency
integral rate of
the DOWN
terminal
0.01–50.00Hz/s
0.50Hz/s
○
P08.47
Action selection
at power-off
during frequency
setting
0x000–0x111
Ones place: Action selection at power-off
during frequency adjusting through digitals.
0: Save the setting at power-off.
1: Clear the setting at power-off.
Action selection at power-off during
frequency adjusting through Modbus
communication
0: Save the setting at power-off.
1: Clear the setting at power-off.
Hundreds place: Action selection at
power-off during frequency adjusting through
other communication methods
0: Save the setting at power-off.
1: Clear the setting at power-off.
0x000
○
P08.48
Initial electricity
consumption
high-order bits
Used to set the initial electricity consumption.
Initial electricity consumption = P08.48*1000
+ P08.49
P08.48 setting range: 0–59999 kWh (k)
P08.49 setting range: 0.0–999.9 kWh
0°
○
P08.49
Initial electricity
consumption
low-order bits
0.0°
○
P08.50
Magnetic flux
braking
Used to enable magnetic flux braking.
0: Disable
100–150: A larger coefficient indicates
stronger braking.
The VFD can quickly slow down the motor by
0
○