IP-COM AP325 - Restoring the AP to Factory Settings

Wireless Access Point
User Guide
Restoring previous configuration
1. Click Tools > Configuration > Backup & Restore.
2. Click Choose File and select the configuration file to be restored.
3. Click Restore and follow the on-screen instructions to perform operations.
4. Click OK.
---End
Verification
A progress bar will appear after you click OK. And the AP is restored to previous configuration after the
progress bar ends.
11.4.2 Restoring the AP to factory settings
If you cannot locate a fault of the AP or forget the login password of the AP, you can reset the AP to
restore its factory settings and then configure it again. The AP can be reset using web UI or hardware.
After you reset the AP, the login IP address of the AP is changed to 192.168.0.254, and the user name and
password of the AP are changed to admin.
Note
AP’s configuration is lost if you restore it to the factory settings. And you need to reconfigure the AP to
connect to the internet. Therefore, restore the factory settings of the AP only when necessary.
To prevent damages, ensure that the AP is connected to power supply properly when the AP is reset.
93