Wireless Access Point
User Guide
8.2 RF
8.2.1 Overview
The RF module is used to set radio parameters of the AP, such as country/region and network mode. It
also enables you to turn on/off the Isolate SSID function. The following describes the Isolate SSID function
briefly.
Isolate SSID
This function isolates the wireless devices connected to different WiFi networks of the AP. For example, if
user A connects to the WiFi network corresponding to SSID1, whereas user B connects to the WiFi
network corresponding to SSID2, the two users cannot communicate with each other after Isolate SSID is
enabled.
8.2.2 Changing the RF settings
1. Choose Wireless > RF.
2. Change the parameters as required. Generally, you only need to change the Enable RF, Channel, and
Lock Channel settings.
3. Click Save.
To Next Page
Loading...
