IP-COM AP325 - Configuring the DHCP Server

Wireless Access Point
User Guide
7.3 DHCP server
7.3.1 Overview
The AP supports the DHCP server function to assign IP addresses to devices connected to it. However, the
AP’s DHCP server function is disabled by default, so as to make the devices connected to the AP can
access the internet successfully.
7.3.2 Configuring the DHCP server
1. To access the configuration page, choose Network > DHCP Server.
2. DHCP Server: Tick Enable.
3. Gateway: Enter the gateway address, which is 192.168.0.1 in this example.
4. Primary DNS Server: Enter the primary DNS server, which is 8.8.8.8 in this example.
5. Click Save.
---End
Parameter description
Parameter Description
DHCP Server
It specifies whether to enable the DHCP server function of the AP. By default, it is
disabled.
Start IP Address
It specifies the start IP address of the DHCP server’s IP address pool. The default
value is 192.168.0.100.
End IP Address
It specifies the end IP address of the DHCP server’s IP address pool. The default
value is 192.168.0.200.
Tip
The start and end IP addresses must belong to the same network segment as the IP
31