Wireless Access Point
User Guide
— Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Radiation Exposure Statement
This device complies with FCC radiation exposure limits set forth for an uncontrolled environment and it also
complies with Part 15 of the FCC RF Rules.
This equipment should be installed and operated with minimum distance 20cm between the radiator & your
body.
Caution:
Any changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate this equipment.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
NOTE: (1) The manufacturer is not responsible for any radio or TV interference caused by unauthorized
modifications to this equipment. (2) To avoid unnecessary radiation interference, it is recommended to use a
shielded RJ45 cable.
Operating temperature: (-10 – 45) °C
Operating humidity: (10% – 90%) RH, non-condensing
Caution:
Adapter Model: BN036-A12012E/BN036-A12012B
Manufacture: SHENZHEN HEWEISHUN NETWORK TECHNOLOGY Co., LTD.
Input: 100-240 V AC, 50/60 Hz, 0.4 A
Output: 12 V DC 1 A
: DC Voltage
112
To Next Page
Loading...
