Wireless Access Point
User Guide
Adding a log server
1. To access the page, click Tools > Logs > Log Settings.
2. Tick the box beside the Enable Log Server Function item.
3. Click Add.
4. Set parameters as follows:
− Log Server IP Address: Enter the IP address of your log server, which is 192.168.0.88 in this
example.
− Log Server Port: Enter the log server’s UDP port number used to send and receive system logs.
The default port number 514 is recommended.
− Enable: Tick the box to enable the log server.
5. Click Save.
---End
The following figure shows the configuration:
90
To Next Page
Loading...
