ISCO 4210 - Page 157

4210 Flow Meter
Appendix B Programming Worksheet
B-5
Data Point Set #1.
Step 3 - Parameter to Adjust
1. Parameter To Adjust: None, Level, pH, D. O., YSI 600____
2. (Job Site only) Enter Current Level: __.____ Ft (or M).
Note
Installations generally use either the Isco parameter probes or
the YSI 600 Sonde, but not both. Use the following menus for
either the Isco probes or the YSI 600 Sonde. Steps 3, 4, and 5
can be used for both 2 and 3-point pH calibrations.
3. Rinse Probe And Place In 4.0 pH Solution: Press Enter
When Stable __.____ pH (job site only)
4. Rinse Probe And Place In 7.0 pH Solution: Press Enter
When Stable __.____ pH (job site only)
5. Rinse Probe And Place In 10.0 pH Solution: Press Enter
When Stable __.____ pH (job site only)
6. (YSI 600 D.O. Calibration only): D.O. Standard, Absolute
Barometric Pressure, Altitude
7. Altitude Units Of Measure: Ft., M (D.O. probe only)___ ___
(job site only)
8. (D.O. only) Enter Altitude: Altitude = _______ Feet (or
meters, at job site only)
9. Wrap D.O. Probe In Moist Cloth: Press Enter When Sta-
ble: __.____ MG/L (job site only)
10. Conductivity Calibration Units: Ms/cm, ppt__________
Level Flow Level Flow Level Flow Level Flow