Iseki SBC950 - Page 111

SCMA54,SCMB60,SSM54
110
• Foreign matter caught in shaft
• Broken wheel
• Short of grease
• Inside of the mower deck is clogged with
too much grass or mud.
• Defective hydraulic system
Troubles Presumable causes
Remedies
Excessive noise and vibration
Too low engine output
Gauge wheels do not turn.
Mower does not rise.
• Deformed or interfering shaft cover
• Damaged bevel gears
• Broken or unbalanced blades
• Loose blade tightening bolts
• Too low engine speed
• Too fast travelling speed
• Foreign matter caught between blade and
blade support
• Defective engine
• Repair it.
• Consult your dealer.
• Replace them with new one.
• Re-tighten them to 1000 kgf •cm.
• Mow at full throttle (
).
• Slow down.
• Clean.
• Consult your dealer.
• Clean.
• Replace it with new one.
• Inject grease.
• Clean.
• Consult your dealer.
• Loose blade tightening bolts
• Foreign matter caught in blades or
blade supports
• Broken bevel gears
Blades do not rotate.
• Re-tighten them to 1000 kgf •cm.
• Clean.
• Consult your dealer.