SF224,235
60
(1) Battery
12. WHEEL TIGHTENING BOLTS AND NUTS
Check the wheel tightening bolts and nuts for looseness
All bolts and nuts should be tightened to the specified
torque.
Specified tightening torque (Bolt):
Front wheel: 45.1 N
・
m
〜
57.9 N
・
m (460 kgf
・
cm
〜
590 kgf
・
cm)
Rear wheel: 127.2 N・m 〜 147.2 N・m (1298 kgf・cm 〜 1502 kgf・cm)
Tighten the bolts near the maximum level and tighten
again so that the groove and hole aligned together,
insert the cotter pin through the hole and groove, sprit
the edge of it.
13. BATTERY
DANGER:
・The battery generates very explosive
gases, so avoid smoking and keep sparks
and open flames away from the battery.
Charging the battery should be done in a
place well ventilated to disperse explosive
gasses as quickly as possible.
・Battery electrolyte is very corrosive and
will cause burns, so if it splashes on skin
or clothes, wash it off immediately. If acid
contacts eyes, flush immediately with
clean water and get medical attention.
・ When using booster cables, take
sufficient safety measures.
■ INSPECTION OF BATTERY
The battery,1, is installed on the middle of the left hand
side of the front mower. Check to see if the electrolyte
level is between the upper and lower limits. When the
level is near to the lower limit or below, raise the level
with distilled water to the upper limit.
WARNING: Never attempt to keep on using
or charging the battery with a electrolyte
level lower than the limit, or the battery may
explode or its service life be shortened due
to deterioration inside the casing.
IMPORTANT: The electrolyte level should always be
kept between the upper and lower limits. A
too high level will cause the electrolyte to
overflow and corrode other parts.
FIG. 72
FIG. 73
1
2
A
B
(1) Battery (2) Filler plug
A Upper limit B: Lower limit
To Next Page
Loading...
