SCMA54,SCMB60,SSM54
88
1. BEFORE OPERATION
CAUTION :
・Become familiar with how to operate
the front mower and understand safety
instructions by reading this manual
carefully.
・Make sure that all safety covers and
guards are installed in position.
・Make sure that the blade bolts are
tightened securely.
・Before moving the front mower into the
working site, check the whole area and
get rid of all obstacles such as stones,
wood, empty tins, bottles, wires, etc to
assure safe operation.
・Make sure that the mower operation will
not cause any injury to children, animals,
bystanders, or damage to trees, buildings,
etc.
・Check the place to mow for bumps,
ditches, mounds, steps, slopes,
inclination, softness, water pools, etc.
beforehand to avoid accidents such as
turnover, fall, side-sliding of the front
mower.
2-1. CUTTING HEIGHT ADJUSTMENT (SCMA54)
(1) Pin (Front gauge wheel) (2) Spring clip (Lift rod)
CHAPTER 3. MOWER OPERATION
a. Depress the brake pedal and then start the
engine.
b. Raise the mower with the lift by shifting the
mower lift lever. Then stop the engine.
c. Remove the pin from the front gauge wheel.
Remove the pin while holding the gauge wheel
with the other hand.
d. Select one of the setting holes to get the required
cutting height, insert the pin, and retain it with the
pin. The label that is showing the relationships
between the setting holes and cutting heights is
stuck on the mower deck.
e. Also set the cutting height of the lift rod by re-
setting the setting hole for the setting pin with the
spring clip removed.
f. The right and left-hand side of lift rods should be
set to the same cutting height.
g. Shift the mower lift lever to the DOWN position to
lower the mower deck.
CAUTION : Before operating the mower lift
lever, be seated in the operator's seat and
make sure of the safety conditions when
lowering the mower deck.
1
2
To Next Page
Loading...
