Iseki SBC950 - 27. Periodical Inspection Table

SF224,235
72
27. PERIODICAL INSPECTION TABLE

: Inspect, replenish or adjust

: Replace

: Clean or wash

: Replacement or servicing at authorized service facility recommended.
Before Operation Initial 50 Hr

100 Hr 150 Hr

200 Hr 250 Hr 300 Hr

350 Hr 400 Hr 450 Hr

500 Hr 550 Hr 600 Hr

1 / Month 1 / Year

1 / 2 Years

Intervals Judgement criteria
Ref.
page
Engine oil

Replace after initial 50 Hr.
and then after every 150 Hr.
Maintain the specified level. 63
Air cleaner



Clean after every 50 Hr.
Replace once / Year or as
required.
55
Radiator coolant

Replace once / 2 Years Maintain the specified level. 66
Fuel

Keep fuel tank always full. 55
Fuel strainer
 
Replace every 300Hr or
once / 1 year
There should be no dust or
water in filter.
56
Fan belt

Replace as required. 10.0mm(0.4 in.) deflection 57
Electrolyte level

Replenish electrolyte as
required.
Level should be kept properly. 68
Battery condition

Charge or replace as
required.
60
Engine oil filter
 
Replace after initial 50 Hr.
and then after every 300 Hr.
64
Transmission oil
    
Replace after initial 50 Hr.
and then after every 300 Hr.
Maintain the specified level. 64
Hydraulic oil filter
  
Replace after initial 50 Hr.
and then after every 300 Hr.
65
Suction filter
  
Clean after initial 50 Hr.
and then after every 200 Hr.
65
Break pedal play

20 to 30 mm (0.8 to 1.2 inch) -
Steering wheel


Check after every 300Hr.
There should be no
abnormality.
62
Ball joints of
steering system
linkage

Check after every 300Hr.
Loose ball joints should be
re-tightened.
-
Tire pressure

62
Toe-in

Adjust after every 300Hr. 2 to 6mm(0.04 to 0.20 inch) 62
Wheel tightening
bolts

There should be no loose nuts. 60
Grease-up
 
Inject grease after every 50Hr 71
Radiator screen

There should be no clogging. 66
Radiator

There should be no clogging. 66
Electrical apparatus

All should work properly. 68
Safety switches

All should work properly. 69
Air intake openings

All should work properly. -
Bolts and nuts

There should be no loose ones. -
Rubber pipes

Check after every 100Hr -
IMPORTANT: • Above mentioned service intervals are for normal usage. If working conditions are harder, earlier
service is recommended.
• If special skill or special tool are required or you feel difficulty in maintenance, consult your dealer.