Iseki SBC950 - Monitor Lamp Array

CHAPTER 5. CONTROLS AND METERS
39
IMPORTANT: Always release the parking brake lever
and make sure that the lamp is turned
off before driving the front mower to pre-
vent abnormal brake wear.
: Engine coolant warning lamp: The lamp
illuminates while the engine coolant is over-
heated.
IMPORTANT: When the engine coolant is over-heated,
the monitor lamp is illuminated, rotation
of the radiator fan is reversed for a few
second, and then PTO is stopped. At the
same time the warning horn sounds for
2 seconds.
When the monitor lamp is illuminated,
reduce engine speed to idle, and wait
until the lamp turns off.
When the lamp turns off, stop the engine
and troubleshoot for overheating (clean
up clogged grass or dust around engine,
radiator and etc.) Then restart operation.
WARNING: When inspecting the radiator, be
sure that the engine cools down sufficiently.
Never release the radiator cap while the
coolant is hot, or boiling water will gush
out.
:
Low beam lamp:
The lamp illuminates while low
beam light of combination switch is ON position.
:
High beam lamp:
The lamp illuminates while
high beam light of combination switch is ON
position.
:
Position lamp:
The lamp illuminates while
position lamp of combination switch is ON
position.
: Selection lamp (Mower PTO lamp): The lamp
illuminates while the mower PTO switch is ON
position.
: Selection lamp (Blower PTO lamp): The lamp
illuminates while the blower PTO switch is ON
position.
:
Glow lamp:
The lamp illuminates when the
starter switch is turned to GLOW position. (The
lamp does not turn off if glow is ready.)
1.7. MONITOR LAMP ARRAY
:
Turn signal lamp (left-hand side):
The lamp is
blinked while the turn signal switch is in the left-
hand turn position, or hazard switch is ON
position.
:
Grass collector lamp:
The lamp works only
when the machine is equipped with the collector.
It illuminates and the warning horn also sounds
when the collector is filled with grass with the
PTO to ON position. When the mower PTO and
blower PTO are turned to OFF, the warning horn
stops. The lamp turns off when the collector
become empty.
: 4WD lamp: The lamp iluminates while 4WD lever
is in the LOCK(PERM) position and turns off while
it is in the AUTO(AUT.) position.
:
Blower PTO at a low speed lamp:
The lamp
illuminates while the blower PTO is at a low
speed .
:
Reverse radiator fan lamp:
The lamp illuminates
while the radiator fan turns in reverse.
:
Oil pressure lamp:
The lamp illuminates when
the engine oil is not circulating normally. It also
illuminates when the key turns to the ON position
or the START position while the engine stops, but
turns off as soon as the engine starts.
: Battery charge lamp: The lamp illuminates while
the battery is not being charged. It also
illuminates up when the key turns to the ON
position or the START position while the engine is
not running, but turns off as soon as the engine
starts.
:
Beacon lamp:
The lamp illuminates while the
beacon is used. Beacon lamp is optional.
:
Mower PTO lamp:
The lamp illuminates while
the mower PTO is operated.
:
Blower PTO lamp:
The lamp illuminates while
the blower PTO is operated.
:
Turn signal lamp (right-hand side):
The lamp
illuminates while the turn signal switch is in the
right-hand turn signal, or hazard switch is ON
position.
:
Fuel empty lamp:
The lamp illuminates while the
fuel tank is empty.
:
Parking lamp:
The lamp illuminates while starter
switch is in the ON position and parking brake is
applied.