CHAPTER 8. MAINTENANCE
69
IMPORTANT: When a slow-blow fuse has been blown
out, use genuine slow-blow fuse.
Slow - blow fuse Parts code
40A 1650-650-222-00
50A 1832-690-203-00
60A 3829-260-303-00
WARNING: Damaged wire covers should be
mended with insulation tape immediately.
CAUTION:
・
The wiring of the front mower should
be checked every year at your dealer to
avoid electrical fires.
・
Grass and dust around the battery, wiring,
muffler and engine should be removed.
Otherwise they may catch fire.
IMPORTANT: When a wire harness has come off
its clamp, it should be re-clamped
immediately.
Harness coupler for beacon lamp, is located in the
behind of the oil cooler.
23. HYDRAULIC SYSTEM PARTS
When hydraulic system parts such as the HST unit,
hydraulic pump, control valve, hydraulic cylinder, piping,
etc. are required to be adjusted or repaired, consult your
ISEKI dealers. Users are advised not to adjust or repair
hydraulic system parts by themselves.
24. SAFETY SWITCHES
Safety devices are installed for safe operation. Make
sure that each device works properly before operation
following procedures.
CAUTION: When the engine does not start
due to a defective safety switch or does
not stop when the operator has left the
operator's seat, consult your dealer.
INSPECTION 1
a. Be seated in the operator's seat.
b. Turn the starter switch to the START position
without depressing the brake pedal. Make sure
that the engine is not cranked.
INSPECTION 2
a. Be seated in the operator's seat.
b. Depress the brake pedal fully.
c. Turn the starter switch to the START position.
Make sure that the engine is cranked and started.
d. Leave from the operator's seat.
Make sure that the engine should stop.
(1) Harness coupler for beacon lamp
(2) Oil cooler
FIG. 89
To Next Page
Loading...
