Iseki SBC950 - Troubleshooting

CHAPTER 6. TROUBLESHOOTING
109
CHAPTER 6. TROUBLESHOOTING
Troubles Presumable causes Remedies
Improper discharging
Grass is not mowed.
Uneven cutting heights
Turf is peeled off in some
places.
Excessive noise and vibration
• Blades are installed upside down.
• Grass is too moist.
• Too tall grass
• Too fast travelling speed
• Too low engine speed
• Clogged discharge or mower deck inside
• Too dense grass
• Improperly installed blades
• Too fast travelling speed
• Too low engine speed
• Worn or broken blades
• Blades are installed upside down.
• Improperly installed blades
• Mower is not parallel to ground.
• Too fast travelling speed
• Worn blades
• Clogged grass inside of mower deck
• Improperly adjusted gauge wheels
• Too tall grass
• Two blades are not installed on the same
level and correct angle.
• Deformed blades
• Too low cutting height.
• Mower is not parallel to ground.
• Too fast turning speed
• Too bumpy ground
• Broken or unbalanced blades
• Loose blade tightening bolts
• Re-install them correctly.
• Wait until grass becomes dry.
• Mow it in two steps.
• Stow down sufficiently.
• Run engine at full throttle (
).
• Clean.
• Mow it in two steps or narrow
cutting width.
• Slow down sufficiently.
• Install blades properly.
• Slow down.
• Run engine at full throttle (
).
• Replace them with new ones.
• Re-install them correctly.
• Install blades properly.
• Adjust mower mounting.
• Slow down.
• Replace them with new ones.
• Clean.
• Adjust them properly.
• Mow it in two steps.
• Correct by shimming and set the
blades properly.
• Replace them with new ones.
• Correct it with gauge wheels.
• Adjust mower mounting.
• Turn slowly.
• Shift mowing direction.
• Replace them with new ones.
• Re-tighten them to 1000 kgf •cm.