EasyManua.ls Logo

Iseki SBC950 - OIL LEVEL (Transmisson, 4 WD, Chain Case and Rear Axle); Coolant Level

Iseki SBC950
128 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SF224,235
54
(1) Reserve tank A: Upper limit B: Lower limit
3. OIL LEVEL (Transmisson, 4WD, chain case and
rear axle)
Transmission oil (FIG.57)
Inspection gauge,1, of oil level is located at the under
side of the collector. Oil filler,2, is located at the side of
the right hand side, and fill in oil by removing cap.
4WD oil (FIG.58)
Inspection plug,3, of oil level is located at the right
hand and under side next to the oil cooler. Oil filler,4,
is located at next to the drain plug, under side of the
engine fan. (Drain plug,5.)
Chain case oil (FIG.59)
Oil filler,6, is located at both LH side and RH side of the
chain case. (Drain plug,7.)
Rear axle oil (FIG.60)
Oil filler,8, is located at RH side of the rear axle and fill in
oil by removing cap. (Drain plug,9.)
4. COOLANT LEVEL
WARNING: Never remove the radiator cap
and reserve tank cap during or just after
operation. The coolant in the radiator is very
hot and highly pressurized, so it may cause
burns. Cool down the engine sufficiently
before inspecting coolant level.
Check the coolant level in the reserve tank,1, is between
the upper,A, and lower,B, limits. If the level is lower than
the lower limit, replenish the reserve tank with coolant.
FIG. 57
FIG. 58
FIG. 61
FIG. 59
FIG. 60

Table of Contents

Related product manuals