ISHIDA WM-NANO - Front Cover Cleaning; Infeed Unit and Weighing Table; Lift Unit Cleaning; Tray Press Cleaning

Chapter 1 Overview
■ Setting a Film
Refer to the instruction manual for setting a film.
This section describes important points for setting.
・ On the front end, set a film so that the end face of the film should be on the plane of
the roller's end face.
A
djust the end plane
<If setting 350 mm film to M type>
Shift the film's end face by 10 mm to the back from the roller's end face to set the
film.
<
350
mm film
>
Film end face
Roller end face
Keep 10 mm gap
・ After adjusting the front end, keep 1 mm gap between the film roll and the film
guide surfaces on the back end. Too much force on the film roll by the film guide
may interfere with film roll rotation.
1-15
Keep 1 mm gap
Film guide
Back
Front
Film roll