Chapter 3 Adjustment Mode
[4] Adjusting film holder position
1） Lower the film holder (set it at the origin position). Adjust the position in this condition and fix the holde
with screws (2).
2） Similarly, adjust the film holder at the other side and fix it.
3） Check that adjustment is complete.
•Adjustment is OK if no gap is found between the
film holder and the film arm with the film holder at
the lowered position (origin position).
If any gap is found, re-adjust the film holde
position.
•Adjustment is OK if a gap is created between the
film holder and the film arm with the film arm in the
pressed condition (conveying position).
If no gap is found, re-adjust the film holde
position.
Film holder
Film holder
Hook and loop
fastener
Roller
Film arm
A gap is
created.
Film holder
Film arm
Film holder
No gap found
Lift the film holder until the roller and the hook
and loop fastener hit each other lightly and fix
the holder with screws (2).
3-41
To Next Page
Loading...
