ITech IT-M7700 Series - [Source:]Output[:State]; Protect:rms:voltage

3-phase/series commands
Copyright© Itech Electronic Co., Ltd. 90
Arguments
<NRf> AC frequency
Query Syntax
[SOURce:]NORMal:FREQuency[:LEVel][:IMMediate]?
Returns
<NRf>
[SOURce:]OUTPut[:STATe]
This command sets the output state of the power supply. This command can
synchronize all output or close.
Syntax
[SOURce:]OUTPut[:STATe] <0|1|OFF|ON>
Arguments
<0|1|OFF|ON> output state
Query Syntax
[SOURce:]OUTPut[:STATe]?
Returns
<0|1|OFF|ON>
PROTect:RMS:VOLTage
This command is used to set the OVPrms value.
Syntax
PROTect:RMS:VOLTage <A|B|C|ALL>, <NRf>
Arguments
<A|B|C|ALL>,<NRf>
Query Syntax
PROTect:RMS:VOLTage? <A|B|C|ALL>
Returns
<NRf|NRf|NRf|NRf,NRf,NRf>