ITech IT-M7700 Series - Example 6: SurgeTrap Function; Example 7: List Function

Programming Examples
Copyright© Itech Electronic Co., Ltd. 110
Please enter the following command:
-> SYSTem:REMote
-> NORMal:MODE AC
-> NORMal:VOLTage:AC 10.0
-> NORMal:FREQuency 50.0
-> NORMal:WAVE SINE
-> NORMal:DIMMer:MODe 1
-> NORMal:DIMMer 90°
-> OUTPut 1
Example 6: Surge/Trap Function
IT-M7700 provides surge/trap simulation. The user can add surge/trap to
simulate abnormal voltage fluctuation on the basis of outputting Sin wave, and
test usage of the DUT under this circumstance. Please enter the following
command:
-> SYSTem:REMote
-> NORMal:MODE AC
-> NORMal:VOLTage:AC 10.0
-> NORMal:FREQuency 50.0
-> NORMal:WAVE SINE
-> NORMal:SURGETRAP:MODe 1
-> NORMal:SURGETRAP:PERIOD 2
-> NORMal:SURGETRAP:WIDTH 1
-> NORMal:SURGETRAP:PERCENT 200%
-> OUTPut 1
Example 7: List Function
Edit List
You can use the list program to perform a variety of output waveform
simulations. The execution flowchart of list program is as follows.