ITech IT-M7700 Series - Example 3: Applying Waveform Output; Example 4: Self-Defined Waveform

Programming Examples
Copyright© Itech Electronic Co., Ltd. 108
Example 3: Applying Waveform Output
The ITM7700 is configured as a waveform generator and outputs 10V/50Hz
Sine wave. Please enter the following command:
-> SYSTem:REMote
-> NORMal:MODE AC
-> NORMal:VOLTage:AC 10.0
-> NORMal:FREQuency 50.0
-> NORMal:PHASe:STARt 45.0
-> NORMal:PHASe:STOP 0.0
-> NORMal:WAVE SINE
-> PROTect:MAX:CURRent:LIMit 20.0
-> OUTPut ON
-> MEASure:VOLTage:AC?
-> MEASure:CURRent:AC?
-> MEASure:POWer?
-> MEASure:POWer:APParent?
-> MEASure:POWer:PFACtor?
-> MEASure:FREQuency?
-> MEASure:THD?
-> MEASure:POWer:REACTive?
Example 4: Self-defined Waveform
Users can self define arbitrary waveforms to simulate or duplicate the real
waveforms. The execution flowchart of Self-defined Waveform is as follows.