ITech IT-M7700 Series Programming Guide

LIST Subsystem(IT-M7700)
Copyright© Itech Electronic Co., Ltd. 64
the Arguments format as: "List total steps, Jump, Repeat, End State, and retain
Arguments". Detailed Arguments are explained below.
Arguments
Descriptions
List total steps
Set the total steps of the real-time list program: 1-50.
Jump
Set the step where the real-time List starts execution: 1-50.
Repeat
Set the number of list repetitions within the range from 1 to
50000.
End State
Set the running state after the list program is running over.
⚫ 0: the instrument output is turned off after the execution
is completed;
⚫ 1: keep outputting the last step when the dwell time is
over.
Retain Arguments
This value is 0.
V Range(IT-M7723)
0: Low range, 1: High range.
Syntax
LIST:CONFigure <String>
Arguments：
<String>
Example
LIST:CONFigure ”50,1,100,0,0”
Query Syntax：
LIST:CONFigure?
Returns：
<String>
LIST:RECOrder
This command is used to set the record Arguments of a single Step in the List.
Record the Arguments format as: Step index value, "Type, Wave Type, Level,
Vac, Vdc, Freq, Time, Start Phase, Stop Phase, Kac, Kdc, Kfreq, Repeat".
Detailed Arguments are explained below.

ITech IT-M7700 Series Specifications

General

Brand	ITech
Model	IT-M7700 Series
Category	Portable Generator
Language	English