computer radio control system
EN
• Center-Beep mode – the transmitter beeps whenever the
control goes to a central position (its deflection is thus 0%).
• Voice mode – the transmitter will vocally announce the
numeric value of the current position of the control. The value is
reported after every change of the control position and only after
the movement is stopped. In this mode, you can also select an audio
file that will alert you when changes in control positions are
detected.
Example: If you generate the “CONTROL.WAV” file and then assign
it as the File parameter, the transmitter announces eg “Control:
twenty-five”.
The setting is always valid for the current model.
4.
4.
114
To Next Page
Loading...
