computer radio control system
EN
4. 4.
1. Ailevator Global or Separate Setting
The Ailevator configuration for both channels can be set collectively
for all flight modes by selecting the “G (globe)” symbol or you can
set individual Ailevator settings in each separate flight mode by
sellecting the “S-Separate” symbol.
2. Ailevator Setting
Ailevator configuration has four different adjustable parameters.
The lines marked “Elevator” and “Aileron” contain two columns
“S1” and “S2” which represent the elevator and aileron surface
throws as a percentage. Scroll and highlight the lines marked as
“Elevator” or “Aileron” with the “3D Control” button and press the
“3D Control” button to access the individual setting of each servo. If
the servos need to be adjusted independantly, use the “F1 (Sym.)”
button to unlock the servo travel for adjusting the individual values
in the selected menu line.
9.2.8 V-Tail Mix
If your model is equipped with a V-Tail, The two basic tail functions
(rudder and elevator) are mixed to control the tail of the airplane.
The V-Tail mix has to be activated by choosing the “V-Tail 2H” tail
setting. Unless you have previously chosen a different percentage
for one of the tail mixes, the initial settings for “V-Tail” function are
50% of the rudder and elevator travels.
1. V-Tail Global or Separate Setting
The V-Tail configuration for both channels can be set collectively for all
flight modes by selecting the “G (globe)” symbol or you can set
individual V-Tail settings in each separate flight mode by sellecting the
“S-Separate” symbol.
2. V-Tail Setting
The V-Tail configuration has four different adjustable parameters. The
lines marked “Elevator” and “Rudder” contain two columns “S1” and
“S2” which represent the elevator and aileron surface throws as a
percentage. Scroll and highlight the lines marked as “Elevator” or
“Rudder” with the “3D Control” button and press the “3D Control”
button to access the individual setting of each servo. If the servos need
to be adjusted independently, use the “F1 (Sym.)” button to unlock the
servo travel for adjusting the individual values in the selected menu line.
91
To Next Page
Loading...
Need help?
General
