computer radio control system
EN
4. 4.
9.3 Advanced Properties
Advanced programming menu for DC/DS. (*depends on equipment)
9.3.1 Other Model Options
This menu contains additional, special features of the DC/DS
transmitters.
1
2
3
4
5
3a
1. Auto-Trim Function
Auto-Trim function can be activated using any assigned switch,
knob or stick. Once this function has been activated you can trim
your model using transmitter gimbals. The direction and speed of
the trim adjustment is determined by stick movement. Larger stick
movements equal a faster trim response. When the Auto-Trim
function is active, the transmitter gimbals do not change their
standard response. The transmitter is still in normal operation mode.
It is advised to use the automatic trim function only for
the maiden flight, after proper trimming is done we
recommend disabling this function.
Advice:
2. Trainer Function
The Trainer function can be set so that it may be activated using any
assigned switch, knob or stick.
3. Telemetry Recording
The Telemetry recording function can be set so that it may be
activated using any assigned switch, knob or stick. The data stream is
recorded on the internal SD memory card. All data can be found in
the “Log” directory of the transmitter software after connecting the
Tx to the PC via a USB port. Active data recording is indicated on the
upper edge of the main desktop screen by a blinking circle. A solid
square graphic indicates that recording is stopped.
3a. Mode
By default ("Auto" mode), the telemetry starts recording after any
timer is activated, Start-logging switch is flipped or Start button on
the main screen is pressed. If the "Start/Stop" mode is selected, the
status of recording is always controlled by the position of your
selected Start-logging switch.
100
To Next Page
Loading...
Need help?
General
