JETI model Duplex DS-16 - Limitations in Copying Models between Transmitters; Usb; Info

computer radio control system
EN
4. 4.
9.6.9 USB
This menu allows you to establish communication between your
DC/DS and a PC once you have connected the two with a USB cable.
How to connect your DC/DS to a PC:
1. Manually enter the menu: „Menu, >System, >USB“
2. When prompted, connect your transmitter and the PC with a
USB cable.
Leaving the menu disables the connection.
Note:
9.6.10 Info
This menu displays information about your DC/DS such as: product
name, firmware version, available memory, etc. Press the „F5 (Ok)“
button to exit this menu.
9.6.8 Limitations in copying models between transmitters
When copying models from one transmitter to another one, it is
necessary to bear in mind that the transmitters may not have the
same software equipment. Thus it is possible that the configuration
of the activated modules may not correspond. In this case it is
necessary to check individual features of the model. Loading the
model memory to a different transmitter with different activated
modules can be carried out, but according to the use of individual
modules the transmitter can display warnings or does not allow
loading the model. The table (9.6.8) shows the conditions under
which a warning message will be displayed indicating that the
model will be loaded in a limited form, or will not load at all.
133