JETI model Duplex DS-16 - Ailevator; V-Tail MIX

computer radio control system
EN
The ailevator function uses two servos for the elevator channel. Both
sides can be programmed to be controlled independently.
If you have this selected as your model’s tail type, you can find the
Ailevator menu in “Fine Tuning, >Ailevator”.
12.3 Ailevator
a. Flight mode setting configuration
b. Elevator travel setting
c. Aileron travel setting
Your model’s roll sensitivity is significantly greater with this mix.
To disable the mix, set your „Aileron“ throw to zero. This will cause
both elevator surfaces to move only when the elevator stick is
moved.
The V-Tail mix function uses two tail servos to control both the
elevator function and the rudder function. See chapter 9.2.8
If you have this selected as your model’s tail type, you can find the V-
Tail menu in “Fine Tuning” -> “V-Tail”
12.4 V-Tail Mix
a. Flight mode setting configuration
b. Elevator travel setting
c. Rudder travel setting
5.
5.
c
b
a
c
b
a
146