computer radio control system
EN
9.4.2 Alarms
If you use the JETI telemetry system, in this menu you can set your
alarm thresholds and choose which sound is played in the alarm
condition. The transmitter supports both first generation Duplex
and Duplex EX alarms.
First Generation Alarms
First generation Duplex (non-EX) sensors generate their alarms as
Morse Code. If you are using first generation Duplex sensors, then
you must select „Enable Morse Code Alarms“ using the „3D
button“. When this option is selected, a table appears. In this table,
the first column shows the Morse Code alphabet. The second
column shows the .wav sound files associated with each letter. Use
the „3D Button“ to change the .wav file association as needed. The
third column shows whether the selected .wav file for each letter is
enabled. Use the „3D button“ to enable or disable the alarm sound
as needed. This configuration must be set for each model and is
saved for each model independently.
1. Creating an Alarm
Use the „F2(Add)“ button to add an alarm. Then, in the „Sensor“
item, select the sensor whose alarm limit you want to set.
4. 4.
EX Alarms
Duplex EX sensors generate their alarms directly to the transmitter.
The corresponding Duplex EX sensor must first be connected to a
Duplex EX receiver and the receiver must be bound to the
transmitter. It may take several minutes for the transmitter to initially
communicate the sensors. The list of connected sensors is found in:
„Main Menu >Timers/Sensors >Sensors/Logging Setup“.
For this operation, both the transmitter and all receivers and sensors
must be connected and powered.
117
To Next Page
Loading...
Need help?
General
