computer radio control system
EN
4.
4.
9.4 Timers/Sensors
- Set up of Timers and Telemetry Sensors (*depends on equipment)
9.4.1 Timers (*depends on equipment)
The DC/DS allows you to simultaneously use up to 10 different
timers. This is useful to separately track motor run times, individual
lap times, total flight time or just about anything else you could
want. You can also name each of the timers. Once you create a timer,
it is displayed in its own box on the desktop screen. The timer values
are stored in each model’s setup. The „Timers“ menu displays a list
of all of the timers you have created.
1. Model Time/Reset Timers at Power Up
By pressing F1() button you can choose which timers will be reset
after turning on the TX or after selecting the model. By default, all
timers with specified Short Reset option are cleared. In addition, it is
possible to have all timers cleared or none. This option is model
specific. The model time runs incrementally during flight (after
pressing F(4) Start button on main screen or after starting any timer).
Button F(3) clears the model time.
It is possible to show the model time on the main screen
„Timers/Sensors->Displayed Telemetry”.
2. Creating a new Timer
From the „Main Menu > Timers/Sensors > Timers“ menu, press the
„F2(Add)“ button to create a new timer.
3. Deleting a Timer
Use the „F3(Del.)“ button to delete the selected timer.
4. Editing Timer Settings
Use either the „F3(Edit)“ button or the „3D button“ to enter the
„Timer Detail“ menu. Then use the „3D button“ to select and edit
the timer settings.
115
To Next Page
Loading...
Need help?
General
