computer radio control system
EN
This safety feature is mainly for models using glow or gasoline
engines as their main source of power. Electric models can also
highly benefit from this safety feature. The Throttle Cut function can
be activated using any assigned switch, knob or stick. By editing the
“Output Value” item, the throttle output will move to the user
defined (completely off) throttle position once the assigned switch
is activated. When the Throttle Cut is active, your throttle stick has no
effect on the throttle output.
You can find the Throttle Cut menu in: „Advanced Properties,
>Other Model Options, >Throttle Cut“.
12.15 Throttle Cut (Kill Switch)
This feature is used to set the idle position for your throttle and will
prevent your engine from shutting-off when you move throttle stick
to its low position. The minimum throttle setting is defined by
editing the “Throttle-Idle Offset” value. When this function has
been activated, the minimum throttle setting (idle point) is defined
by the offset value as a percentage. Standard throttle function is not
affected by the idle offset setting. You can find the Throttle Cut menu
in: „Advanced Properties, >Other Model Options, >Throttle Idle“.
12.16 Throttle Idle
5.
5.
155
To Next Page
Loading...
Need help?
General
