computer radio control system
EN
When replacing the switch it is also necessary to Sa
remove the switches and from the transmitter Sb Sc
body.
When replacing the switch it is also necessary to Sc
remove the switch from the transmitter body.Sb
When replacing the switch it is also necessary to Sh
remove the switches and from the transmitter Sg Sf
body.
When replacing the switch it is also necessary to Sf
remove the switch from the transmitter body.Sg
Note:
After you turn on the transmitter for the first time after any switches
have been modified, you will notice that the configuration for a
selected model no longer matches.
4.6 Digital Trims
Transmitter gimbals are used for controlling the basic flight
functions like throttle, roll(aileron), pitch(elevator), and yaw(rudder).
Immediately under the transmitter gimbal sticks you can see four
push-buttons which are the programmable, digital trim buttons.
The digital trims are used for fine trimming of the flying model. When
the transmitter is turned off, the trim values are stored in memory
and are recalled when the system is turned back on.
Every model has its own trim setup. Also all flight modes may be
configured to use different trim configurations. By pressing one of
the buttons, the screen will automatically change to display the
graphic position of that trim. The transmitter trims feature an
acoustic step and centre beep alarm.
In the „Digital trim“ menu it‘s possible to enable a special
function used as automatic trimming. Digital trim steps and trim
range setting is explained in „Main menu->Fine tuning/flight
modes->Digital trim“
2.2.
39
To Next Page
Loading...
Need help?
General
